blob: 2a98fb1262310275849d0451221f3fc671b04a47 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
|
<section xmlns="http://docbook.org/ns/docbook"
xmlns:xlink="http://www.w3.org/1999/xlink"
xmlns:xi="http://www.w3.org/2001/XInclude"
version="5.0"
xml:id="sec-declarative-containers">
<title>Declarative Container Specification</title>
<para>
You can also specify containers and their configuration in the host’s
<filename>configuration.nix</filename>. For example, the following specifies
that there shall be a container named <literal>database</literal> running
PostgreSQL:
<programlisting>
containers.database =
{ config =
{ config, pkgs, ... }:
{ <xref linkend="opt-services.postgresql.enable"/> = true;
<xref linkend="opt-services.postgresql.package"/> = pkgs.postgresql96;
};
};
</programlisting>
If you run <literal>nixos-rebuild switch</literal>, the container will be
built. If the container was already running, it will be updated in place,
without rebooting. The container can be configured to start automatically by
setting <literal>containers.database.autoStart = true</literal> in its
configuration.
</para>
<para>
By default, declarative containers share the network namespace of the host,
meaning that they can listen on (privileged) ports. However, they cannot
change the network configuration. You can give a container its own network as
follows:
<programlisting>
containers.database = {
<link linkend="opt-containers._name_.privateNetwork">privateNetwork</link> = true;
<link linkend="opt-containers._name_.hostAddress">hostAddress</link> = "192.168.100.10";
<link linkend="opt-containers._name_.localAddress">localAddress</link> = "192.168.100.11";
};
</programlisting>
This gives the container a private virtual Ethernet interface with IP address
<literal>192.168.100.11</literal>, which is hooked up to a virtual Ethernet
interface on the host with IP address <literal>192.168.100.10</literal>. (See
the next section for details on container networking.)
</para>
<para>
To disable the container, just remove it from
<filename>configuration.nix</filename> and run <literal>nixos-rebuild
switch</literal>. Note that this will not delete the root directory of the
container in <literal>/var/lib/containers</literal>. Containers can be
destroyed using the imperative method: <literal>nixos-container destroy
foo</literal>.
</para>
<para>
Declarative containers can be started and stopped using the corresponding
systemd service, e.g. <literal>systemctl start container@database</literal>.
</para>
</section>
|