import ./make-test-python.nix ({ pkgs, lib, ...}:
{
  name = "connman";
  meta = with lib.maintainers; {
    maintainers = [ rnhmjoj ];
  };

  # Router running radvd on VLAN 1
  nodes.router = { ... }: {
    imports = [ ../modules/profiles/minimal.nix ];

    virtualisation.vlans = [ 1 ];

    boot.kernel.sysctl."net.ipv6.conf.all.forwarding" = true;

    networking = {
      useDHCP = false;
      interfaces.eth1.ipv6.addresses =
        [ { address = "fd12::1"; prefixLength = 64; } ];
    };

    services.radvd = {
      enable = true;
      config = ''
        interface eth1 {
          AdvSendAdvert on;
          AdvManagedFlag on;
          AdvOtherConfigFlag on;
          prefix fd12::/64 {
            AdvAutonomous off;
          };
        };
      '';
    };
  };

  # Client running connman, connected to VLAN 1
  nodes.client = { ... }: {
    virtualisation.vlans = [ 1 ];

    # add a virtual wlan interface
    boot.kernelModules = [ "mac80211_hwsim" ];
    boot.extraModprobeConfig = ''
      options mac80211_hwsim radios=1
    '';

    # Note: the overrides are needed because the wifi is
    # disabled with mkVMOverride in qemu-vm.nix.
    services.connman.enable = lib.mkOverride 0 true;
    services.connman.networkInterfaceBlacklist = [ "eth0" ];
    networking.wireless.enable = lib.mkOverride 0 true;
    networking.wireless.interfaces = [ "wlan0" ];
  };

  testScript =
    ''
      start_all()

      with subtest("Router is ready"):
          router.wait_for_unit("radvd.service")

      with subtest("Daemons are running"):
          client.wait_for_unit("wpa_supplicant-wlan0.service")
          client.wait_for_unit("connman.service")
          client.wait_until_succeeds("connmanctl state | grep -q ready")

      with subtest("Wired interface is configured"):
          client.wait_until_succeeds("ip -6 route | grep -q fd12::/64")
          client.wait_until_succeeds("ping -c 1 fd12::1")

      with subtest("Can set up a wireless access point"):
          client.succeed("connmanctl enable wifi")
          client.wait_until_succeeds("connmanctl tether wifi on nixos-test reproducibility | grep -q 'Enabled'")
          client.wait_until_succeeds("iw wlan0 info | grep -q nixos-test")
    '';
})