1 files changed, 50 insertions, 0 deletions
diff --git a/nixpkgs/nixos/doc/manual/configuration/ipv6-config.xml b/nixpkgs/nixos/doc/manual/configuration/ipv6-config.xml
new file mode 100644
index 000000000000..675a5d9a260d
--- /dev/null
+++ b/nixpkgs/nixos/doc/manual/configuration/ipv6-config.xml
@@ -0,0 +1,50 @@
+<section xmlns="http://docbook.org/ns/docbook"
+         xmlns:xlink="http://www.w3.org/1999/xlink"
+         xmlns:xi="http://www.w3.org/2001/XInclude"
+         version="5.0"
+         xml:id="sec-ipv6">
+ <title>IPv6 Configuration</title>
+
+ <para>
+  IPv6 is enabled by default. Stateless address autoconfiguration is used to
+  automatically assign IPv6 addresses to all interfaces. You can disable IPv6
+  support globally by setting:
+<programlisting>
+<xref linkend="opt-networking.enableIPv6"/> = false;
+</programlisting>
+ </para>
+
+ <para>
+  You can disable IPv6 on a single interface using a normal sysctl (in this
+  example, we use interface <varname>eth0</varname>):
+<programlisting>
+<xref linkend="opt-boot.kernel.sysctl"/>."net.ipv6.conf.eth0.disable_ipv6" = true;
+</programlisting>
+ </para>
+
+ <para>
+  As with IPv4 networking interfaces are automatically configured via DHCPv6.
+  You can configure an interface manually:
+<programlisting>
+<link linkend="opt-networking.interfaces._name__.ipv6.addresses">networking.interfaces.eth0.ipv6.addresses</link> = [ {
+  address = "fe00:aa:bb:cc::2";
+  prefixLength = 64;
+} ];
+</programlisting>
+ </para>
+
+ <para>
+  For configuring a gateway, optionally with explicitly specified interface:
+<programlisting>
+<xref linkend="opt-networking.defaultGateway6"/> = {
+  address = "fe00::1";
+  interface = "enp0s3";
+};
+</programlisting>
+ </para>
+
+ <para>
+  See <xref linkend='sec-ipv4' /> for similar examples and additional
+  information.
+ </para>
+</section>