diff options
Diffstat (limited to 'nixos/doc/manual/configuration/ad-hoc-network-config.xml')
| -rw-r--r-- | nixos/doc/manual/configuration/ad-hoc-network-config.xml | 18 |
1 files changed, 7 insertions, 11 deletions
diff --git a/nixos/doc/manual/configuration/ad-hoc-network-config.xml b/nixos/doc/manual/configuration/ad-hoc-network-config.xml index c53b9598109c..00e595c7cb7f 100644 --- a/nixos/doc/manual/configuration/ad-hoc-network-config.xml +++ b/nixos/doc/manual/configuration/ad-hoc-network-config.xml @@ -3,22 +3,18 @@ xmlns:xi="http://www.w3.org/2001/XInclude" version="5.0" xml:id="ad-hoc-network-config"> + <title>Ad-Hoc Configuration</title> -<title>Ad-Hoc Configuration</title> - -<para>You can use <xref linkend="opt-networking.localCommands"/> to specify -shell commands to be run at the end of -<literal>network-setup.service</literal>. This is useful for doing -network configuration not covered by the existing NixOS modules. For -instance, to statically configure an IPv6 address: - + <para> + You can use <xref linkend="opt-networking.localCommands"/> to specify shell + commands to be run at the end of <literal>network-setup.service</literal>. + This is useful for doing network configuration not covered by the existing + NixOS modules. For instance, to statically configure an IPv6 address: <programlisting> <xref linkend="opt-networking.localCommands"/> = '' ip -6 addr add 2001:610:685:1::1/64 dev eth0 ''; </programlisting> - -</para> - + </para> </section> |